Hello,
I ordered a CT13s hull, it should be ready and shipped this month so I am looking for hardware.
Can you recommend a strut and rudder for this 1/10 hydroplane?
Thanks in advance!
Hello,
I ordered a CT13s hull, it should be ready and shipped this month so I am looking for hardware.
Can you recommend a strut and rudder for this 1/10 hydroplane?
Thanks in advance!
Hello this is a Top Hydro that much fun congratulations. The best combo that you can go with Lehner 3060/8 einmotorig travel time fits then so about 5 minutes. or what is your plan ?
greeting Harald
Ach so 70cm danke für die Belehrung immer wieder schön die Reaktionen wenn
was überlesen wird.
Soweit ich weiss liegt ihr beide verkehrt. Das ist ein 80 cm Hydroplane.
Gruß
Klaus
Hallo,
meine CT13s ist genau 80,5 cm Lang.
Gruß Erik
Wahrscheinlich ist dem Erik seine schon lackiert :-)
Meine ist genauso lang...unlackiert :-D
Meine ist auch noch nicht lackiert!
The CT13s is almost ready for the water. I bought a turnfin bracket which should fit the ct13s, but the back of the transom of the front sponson is not 90 degrees from the hull. It's angled in 2 directions (outwards and downwards).
Are there turnfin brackets that fit without filing or cutting?
This bracket is for a straight backside of the sponson:
Looks like this:
I did file it down to get it as straight as posible, but I'm afraid it is not a 100% right.
Lesezeichen